Mitsubishi Electronics KA50 Air Conditioner User Manual


 
9
5. Press the Mode (Return) button 2 to complete the setting procedure
and return to the standard control screen.
6. If the air conditioner is already running, the timer starts countdown
immediately. Be sure to check that the timer setting appears cor-
rectly on the display.
ss
ss
sChecking the Current Auto Off Timer Setting
1. Be sure that the Auto Off is visible on the screen (at 1).
2. Hold down the Timer Menu button B for 3 seconds, so that Moni-
tor is indicated on the screen (at 4).
The timer remaining to shutdown appears at 5.
3. To close the monitor and return to the standard control screen, press
the Mode (Return) button 2.
ss
ss
sTo Turn Off the Auto Off Timer...
Hold down the Timer On/Off button 9 for 3 seconds, so that Timer Off
appears (at 6) and the timer value (at 7) disappears.
Alternatively, turn off the air conditioner itself. The timer value (at 7) will
disappear from the screen.
ss
ss
sTo Turn On the Auto Off Timer...
Hold down the Timer On/Off button 9 for 3 seconds. The Timer Off
indication disappears (at 6), and the timer setting comes on the display
(at 7).
Alternatively, turn on the air conditioner. The timer value will appear at
7.
2.8. Locking the remote controller buttons (Operation
function limit controller )
If you wish, you can lock the remote controller buttons. You can use the
Function Selection of remote controller to select which type of lock to
use. (For information about selecting the lock type, see section 2.10. [4]-
2. (1)).
Specifically, you can use either of the following two lock types.
1 Lock All Buttons:
Locks all of the buttons on the remote controller.
2 Lock All Except ON/OFF:
Locks all buttons other than the ON/OFF button.
Note:
The Locked indicator appears on the screen to indicate that buttons are cur-
rently locked.
AFTER
TIMER
OFF
AUTO OFF
5
1
4
Timer Setting
˚C
˚C
AUTO OFF
6
7
AUTO OFF
7
˚C
˚C
AFTER OFF
AUTO OFF
6
7
˚C
˚C
TIME SUN
FUNCTION
PAR-21MAA
ON/OFF
FILTER
CHECK
OPERATION
CLEAR
TEST
TEMP.
MENU
BACK DAY
MONITOR/SET
CLOCK
ON/OFF
4
1
1
Lock Indicator
2. Operation
ss
ss
sHow to Lock the Buttons
1. While holding down the Filter button 4, press and hold down the
ON/OFF button 1 for 2 seconds. The Locked indication appears on
the screen (at 1), indicating that the lock is now engaged.
* If locking has been disabled in Function Selection of remote con-
troller, the screen will display the Not Available message when
you press the buttons as described above.
If you press a locked button, the Locked indication (at 1) will blink
on the display.
ss
ss
sHow to Unlock the Buttons
1. While holding down the Filter button 4, press and hold down the
ON/OFF button 1 for 2 secondsso that the Locked indication
disappears from the screen (at 1).
˚C
˚C
FUNCTION
1
˚C
˚C
FUNCTION
1
˚C
˚C
1