Filter
Top Products
When to change the thread
lifters
The thread lifters on the suction inlet to
the floorhead and upholstery nozzle
can be replaced.
Check them from time to time and
replace them if the pile has worn down.
To replace the thread lifters
^
Use a knife or similar object to
remove them from the slots.
^
Fit the new thread lifters.
Upholstery nozzle, 190 mm
(supplied as standard, depending on
model)
^ Disengage the thread lifter unit at
each side of the upholstery nozzle
using a coin.
^ Fit a new thread lifter unit and lock
into position.
If threads or hair have wound round
the bearing on the floorhead roller:
a Release the bearing (with bayonet
fitting) using a coin.
b Press the bearing out, and remove.
c Take out the roller.
Remove any threads and hair, replace
the roller and refit the bearing.
Replacement parts are available from
your Miele dealer or from Miele (see
back cover for contact details).
Maintenance and care
30