Miele S 388 Vacuum Cleaner User Manual


 
~
Do not vacuum up any inflammable
or combustible liquids or gases and do
not vacuum in areas where such
substances are stored. The cleaner
might explode.
~
Do not vacuum up items which are
heavy, hard or have sharp edges. They
could cause a blockage and damage
the appliance.
~
Floor attachments, accessories and
tubes must not be used at head level to
avoid the risk of injury, e.g. to eyes and
ears.
~
Monitor the change dustbag
indicator and change the dustbag if
necessary. Check the exhaust and dust
compartment filters at the same time
and change them too if necessary. A
full bag or blocked filter will reduce the
suction power of the cleaner. A
temperature limiter switches the
vacuum cleaner off automatically if it
gets too hot. See "Problem solving
guide".
Accessories
Miele accessories including
floorheads, filters and dustbags are
available to order from your Dealer,
the Miele Spare Parts Department or
via the internet on
www.miele-shop.com.
~
The Miele Electrobrush is a motor
driven accessory for use only with Miele
vacuum cleaners. The cleaner must not
be used with an electrobrush produced
by another manufacturer.
~
To avoid the risk of injury when
vacuuming with a Miele Electrobrush or
Turbobrush, do not touch the rotating
roller brush.
~
It is not advisable to vacuum directly
with the handle, i.e. without an
accessory attached as the rim could
get damaged and you could hurt
yourself on sharp edges.
~
Miele vacuum cleaner bags are
disposable and intended to be used
only once. Do not attempt to re-use.
Blocked pores reduce the efficiency of
the cleaner.
~
To ensure safety only use genuine
Miele dustbags, filters and accessories.
This will ensure optimum performance
of the appliance throughout its life.
~
Do not use aroma capsules if your
cleaner is fitted with an ACTIVE HEPA
filter or an Active Air Clean filter. The
active charcoal layer in the filter will
absorb the aroma from the capsules
rendering them ineffective.
The manufacturer cannot be held
liable for damage caused by
non-compliance with these Warning
and Safety instructions.
Warning and Safety instructions
8