Miele S184 Vacuum Cleaner User Manual


 
10
SERVICING AND REPAIRS
Use only genuine Miele replacement parts.
DISCONNECT THE CLEANER FROM THE ELECTRICAL SUPPLY
If you have any questions, contact your local dealer / service agent.
Any service needed other than that described in these Operating Instructions should be
performed by a Miele Service Center, only.
To replace any of the following parts, place the vacuum cleaner in the horizontal position
by using the pedal. Then turn it over exposing the underside.
HOW TO REPLACE - DRIVE BELT
(Part # S01Z6000) AND BEATER BAR
ASSEMBLY (Part # R98Z6064)
1. Remove the 4 screws from the base plate and
lift it off. (Fig. 1)
2. Release the belt from the motor shaft and lift
the beater bar assembly to remove the belt.
(Fig. 2)
3. To reassemble the beater bar, return the belt to
the motor shaft and beater bar pulley.
Re-insert the bar into its supports and turn the
beater bar to ensure that the belt is seated
correctly. (Fig. 3)
4.Replace the base plate, and re-fasten the
screws securely.
HOW TO REPLACE - BEATER BAR / SIDE
BRUSHES / SHAFT SUPPORT A-B
1.First remove the base plate, drive belt and
beater bar assembly (as illustrated above).
2.Remove the 2 screws at both ends of the
beater bar assembly and separate the different
parts as shown in the exploded view.
3.Replace any damaged part and reassemble in
the reverse order.
REPLACING THE HEAD-LIGHT BULB
(S184 only)
1. Remove the base plate, release the head-light
assembly and lift it off. (Fig. 1)
2. Remove the old bulb, and replace it with a new
one (Fig. 2)
(Consult your dealer / service agent for a
suitable replacement bulb).
3.Re-insert the head-light assembly and the
base plate.
REMOVE PLUG BEFORE
REMOVING THIS COVER
Fig. 2
Screw
Screw
Side
Brush
Side
Brush
Rotary brush
Shaft
support
Shaft
support
A
B
Fig. 3Fig. 1
Fig. 2Fig. 1