Filter
Top Products
Selecting the suction power setting
You can adjust the suction power to suit
your preference.
Rotary selector (see fig. 15)
^
Turn the suction power selector to the
desired setting.
PremiumLine Models (see fig. 16)
a "Automatic" button
b +/- controls, to set the desired
suction power setting
c § "Thermo" indicator
d Blockage protection indicator
e Service indicator (reset button)
f "Carpet" indicator, the Powerbrush
was turned on using the Carpet/Floor
button on the hand piece.
+/- Controls (see fig. 17)
The symbols on the control panel
indicate what each setting is
recommended for:
a curtains, lightweight fabrics
b upholstery, cushions
c thick pile carpets, rugs and
runners
( energy saving, daily vacuuming
with low noise level
e low pile carpets
f hard flooring and intensive
cleaning of carpets.
^
To select a higher power setting,
press the + button.
^
To select a lower power setting,
press the - button.
The selected power level is displayed
with a yellow light.
"Automatic" setting (see fig. 18)
(models with +/- controls)
If the "Automatic" setting is selected,
the vacuum cleaner will automatically
adjust the suction power level to suit
the surface being cleaned.
^ Press the "Automatic" button.
The button lights yellow.
To deactivate the setting, press the
"Automatic" button again.
,
Do not use the this setting to
vacuum draperies or other
lightweight fabrics. Excessive
suction may cause damage.
Note (see fig. 19):
To adjust to changing floor heights,
e.g. carpet edges, thresholds, etc.,
briefly step on the release button to
raise the front of the vacuum cleaner.
en
11