Filter
Top Products
Preparing the worktop
^
Make the worktop cut-out following
the dimensions applicable.
Remember to maintain a minimum
safety distance from the back wall,
as well as from any tall unit or side
wall to the right or left of the hob. See
"Safety instructions for installation".
^
Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
If, during installation, you find that the
seals on the corners of the frame are
not flush with the worktop surface,
the corner radius (ß R4) can be
carefully scribed to fit.
Installing the hob
^
Feed the connection cable down
through the cut-out.
^
Place the hob in the cut-out without
securing it.
^
Connect the hob to the mains (see
"Electrical connection").
^
Connect the appliance to the gas
supply (see "Gas connection").
^ Secure the appliance using the
brackets a supplied.
Installation
39