Filter
Top Products
The control is used to ignite the burner and to regulate the
strength of the flame.
ßThe gas supply is turned off
& Strong flame
/ Weak flame
The burners can only be switched on by pressing in the
appropriate control and turning it anti-clockwise, and
switched off by turning the control clockwise.
The following will cause damage to the appliance:
- Switching the burner on without pressing the control
down,
- Switching the burner on by turning the control
clockwise,
- Switching the burner off by turning the control anti-
clockwise.
The manufacturer will not accept liability for any damage
resulting from incorrect operation.
Switching on
^ The control for the burner required must be pressed in and
turned anti-clockwise to the large flame symbol to switch
on.
Pressing a burner control will automatically create a spark
on all burners. This is normal and no cause for concern.
^
When the flame ignites, keep the control pressed in for
8-10 seconds, and then let it go.
^
If the flame goes out, turn the control back to "ß". Wait for at
least 1 minute before attempting to re-ignite it, and press
and hold in the control for longer if required.
^
If the burner refuses to ignite the second time, turn the
control back to "ß" and see section "Problem solving guide".
Operation
20