Filter
Top Products
Service indicator with reset button [
(see fig. 34)
The indicator light will come on after
approx. 50 hours of operation, which is
equivalent to one year of average use.
Check if the motor protection filter and
the exhaust filters need to be replaced
as well. You will need to reset the
indicator after replacing any of these
components.
To do this, the vacuum cleaner must be
turned on.
^
Press the reset button [.
The service indicator will go out and be
reset to its original position.
The reset feature only works
properly if the indicator light has
already come on, but not if the reset
button is pressed in between filter
changes.
Removing hair and threads from the
Powerbrush (see fig. 35)
^
Turn off the vacuum and unplug it
from the outlet.
^
Release the body of the vacuum
cleaner and lower it to the floor
(see fig. 12).
^
Turn the vacuum cleaner over.
^
Use scissors to cut any threads or
hair that have wound around the
roller brush. Guide the scissors along
the guide track on the beater bar.
The trimmings will be drawn into the
vacuum cleaner by the suction once
the vacuum cleaner is turned on.
Blockages (see fig. 36 + 37)
If there are large particles or other
blockages at the base of the suction
hose, you can open it up to clear the
passage.
^
Click the vacuum cleaner into the full
upright position.
^
Press the release button on the
telescopic wand and remove the
handle from the suction hose
^
Guide the swivel elbow at the end of
the suction hose over the catch
hooks, to increase the stability the
vacuum cleaner (see fig. 21).
A Undo the suction hose in the
direction of the arrow.
B Pull the suction hose connector off
the swivel elbow.
^ Remove all blockages
^ Put the connector back on and click
it shut.
If you still have not been able to remove
the obstruction(s), there is another
method you can try.
Open the service flap on the bottom
rear of the vacuum cleaner.
A Use a coin to undo the two screws
until they stop.
B Pry the service flap free.
^
Remove all blockages.
Put the service flap back on and screw
into place.
en
17