Filter
Top Products
What if … Possible fault Fix
dishes are not clean? The dishes were not
loaded correctly.
See, "Loading the dish
-
washer".
The program was not
powerful enough.
Select a more intensive
program see, "Program
guide".
Not enough detergent
was used.
Use more detergent, see,
"Adding detergent".
The spray arm jets are
clogged.
Clean the spray arm jets,
see, maintenance instruc
-
tions.
The triple filter is clogged
or not correctly seated.
Clean and/or reseat the fil
-
ter, see, maintenance in
-
structions.
The drain pump or the
non-return valve may be
blocked.
Clean the drain pump and
the non-return valve, see
maintenance instructions.
tea or lipstick stains
have not been com-
pletely removed?
The wash temperature of
the selected program was
too low.
Select a program with a
higher temperature.
Not enough detergent
was used.
Use more detergent.
white residue is visible
on cutlery and dishes,
clouding occurs on
glassware and film can
be wiped off?
Not enough rinse aid was
used.
Increase the dosage,
see "Before using for the
first time".
The salt reservoir is
empty.
Add reactivation salt,
see "Before using for the
first time".
The salt reservoir cap was
not correctly screwed on.
Reseat it making sure it
screws back on correctly.
The programmed setting
of the water softener is too
low.
Adjust the setting of the
water softener , see "Be
-
fore using for the first
time".
there is a bluish sheen
on the surface of
glasses and film can be
wiped off?
The rinse aid dosage is
set too high.
Reduce the dosage, see
"Before using for the first
time".
Frequently asked questions
42