Filter
Top Products
INDEPENDENT OUTFEED CLUTCH BELT RE
-
PLACEMENT
1. Move the Independent Outfeed Clutch control lever to
“STOP” (up).
2. Extend the PTO drive shaft out straight and lower the
tractor end down to ground level.
3. Unlatch and raise the hinged top, front chain shield
assembly.
4. Remove the clutch bottom bracket - “belt pan.”
5. Roll off the old Double V-Belt from the two pulleys.
6. Slide off the old belt down the length and over the end
of the PTO drive shaft.
7. Install new Double V-Belt onto the two pulleys and
check for proper engage, “RUN” tension. Adjust as
needed.
8. Refasten the clutch bottom bracket - “belt pan and the
PTO input shaft cover.‘
9. Lower and latch close the hinged top, front chain
shield assembly.
10. Raise PTO driveshaft from ground level and return it
to the PTO storage bracket.
INDEPENDENT OUTFEED CLUTCH ADJUSTMENT
Lengthen or shorten linkage bolt with jam nut to create
moderate tension on the Double V-Belt when engaging
the Independent Outfeed Clutch control lever into the
“Run” position.
3200 & 4200 Series -- 29 --
INDEPENDENT OUTFEED CLUTCH (Shield Removed for Illustra
-
tion Purposes Only)
INDEPENDENT OUTFEED CLUTCH ADJUSTMENT