Filter
Top Products
22
INSTALL FIREBRICK
Place firebrick into unit as follows:
1. Place two longer bricks with bevel cuts against the
rear wall of the firebox. See figure 17.
2. Place remaining two bricks with bevel cuts against
the front wall of firebox.
3. Place rectangular brick along side walls of firebrick as
illustrated. If Rectangular bricks are two different widths,
then an equal number of each will go on both sides of
firebox.
INSTALL OPTIONAL CATALYTIC
COMBUSTOR (MODEL 2900/4000)
NOTE: Optional catalyst not recommended with 6" flue
adapter. Smoke spillage may occur out of door when
refueling.
Greater efficiency can be obtained when burning wood
by use of a catalytic combustor. In addition, it will de
-
crease the accumulation of creosote and diminish the
possibility of a chimney fire.
RETAINER
CENTER
RETAINER
RETAINER
RIGHT FRONT BAR
(NOTE LONG SHAFT ON
FRONT)
LEFT FRONT BAR
REAR BAR
FIGURE 16 INSTALL OPTIONAL SHAKER GRATE FOR MODEL 526
HANDLEREAR FRAME
GEARSLOCKNUTS
FRONT FRAME
BEVEL CUT BRICKS
FRONT & BACK
RECTANGULAR
BRICKS ON
SIDES
MODELS 2900/4000
RECTANGULAR
BRICKS ON SIDES
BEVEL CUT BRICKS
FRONT & BACK
MODEL 526
FIGURE 17 INSTALL FIREBRICK