Filter
Top Products
• Black wire = “Y” connection on thermostat. This wire is for the cooling
mode.
9. Putting it all together:
At this point the unit can be placed back into its compartment, and all the power, water
hoses and ducting should be available and ready to connect:
IMPORTANT
DO NOT CUT ANY EXCESS WATER HOSE , WIRE OR DUCTING BEFORE
DETERMINING THAT ALL REQUIREMENTS CAN BE MET WHEN UNIT IS
SECURED.
Position the air conditioner unit so "water in" and "water out" hoses can be attached
without kinking. Now check the air splitter and ducting for fit. Make sure that all
ducting bends are as slight as possible to keep air restriction to a minimum. Once you are
satisfied with the compromises you have made between the water and the air
connections, locate a place for the electric box. Remember this box may be mounted
in any attitude, but must never get wet. Now, before cutting any excess hose, etc.,
check to see that all four air conditioner mounting screws can be installed without
making contact with the hull.
Note: Enclosed in the kit is a "S" shaped flat metal bracket with a hole drilled in
one end of the "S". This is the "hold down bracket" for the fourth mounting screw.
This bracket will slip over the side of the evaporator condensation pan and the
fourth mounting screw will be used to secure it. Because this bracket can be placed
anywhere on the pan, you have a good deal of latitude in tight situations for
installing the screw.
The air conditioner unit may now be secured. For vibration reduction, ensure the
included foam insulation mounting pad is under the air conditioning unit. Do not secure
the electric box at this time.
Next, cut the water hoses to fit and attach each hose with two s/s hose clamps. Make sure
that each hose is placed on the proper end of the condensing coil as marked ("water-
in/water-out"). BE SURE TO REMOVE THE PLASTIC CAPS ON THE WATER-
IN/WATER-OUT ENDS OF THE CONDENSING COIL. THESE WERE
INSTALLED FOR SHIPPING PURPOSES ONLY.
Connect the clear 3/8 inch hose to the nipple on the condensation pan. This hose
generally fits snugly without a hose clamp.
Using the full length of the electric box cable or unpluging the cable, bring the box out to
where it is more convenient for you to work with in making all the required connections.
(SEE WARNING BELOW)