Mellerware 3 5 5 3 0 Electric Heater User Manual


  Open as PDF
of 6
 
5.) ANTI-FREEZE SETTING
Pressthe“powersetting”buttonanditisrecommended
to select the maximum power level. Set the temperature
to5˚Cwiththe“-“button.Whensetthisway,the
appliance will switch on automatically only if the room
temperaturefallsbelow5˚C,topreventfreezingat
minimum energy consumption.
6.) USING OF BOOKING TIMER
NOTE: If you want to operate the appliance in the auto
mode,pressthebutton“bookingtimer”toactivateit.
I In this mode, the function of the timing will be
i invalidated.
Pressthebutton“bookingtimer”oneormoretimes
within 5 seconds to select the booking timing mode, as
per the following sequence:
The booking timing mode setting can be circulated as
above sequence and the yellow timing pilot light will be
on during the heater operating in auto mode.
a. Auto on
WhentheLCDshows“AUTOON”,theunitcomesinto
auto power on timing state. To select what time you
requiretheheatertobeon,pushthebutton“hour”
and“minute”untilyourrequiredoperatingtimeappears.
b. Auto off
WhentheLCDshows“AUTOOFF”,theunitcomesinto
auto power off timing state. To select what time you
requiretheheatertobeoff,pushthebutton“hour”
and“minute”untilyourrequiredoperatingtimeappears.
The operating time has a span of 24 hours. Auto on and
autooffdefaultvalueis”00:00”.
c. Auto
Pressthebutton“bookingtime”untiltheLCDappears
“AUTO”.Thisindicatesthattheautomodecomesinto
effect. The yellow timing pilot light now lights up.
During operating in the auto mode, you can use the
“+”buttonor“-”tosetthedesiredcomforttemperature
as described above and the appliance will
automatically switch on or off at the preset time
and automatically maintain the preset comfort
temperature.
NOTE: Donotpressthebutton“powersetting”when
operating in the auto mode, this will cancel the function
of“bookingtimer”.
Tocancelthefunctionof“bookingtimer”,pressthe
button“bookingtimer”untilblankappearsandwaitfor
5secondsorpressthebutton“powersetting”,the
yellow timing pilot light will go out.
NOTE: To keep the heater’s memory programmed,
always leave the heater plugged in at the mains
socket. If the heater looses its electricity supply, e.g.
switched off at the mains socket or in the event of a
power failure, the heater’s programs will be lost, and
the heater will not work until reset.
This heater includes an overheat protection system
that shuts off the heater when parts of the heater
are getting excessively hot. Once it occurs, the heater’s
programs will be lost.
To completely shut the heater off, turn the controls and
power to OFF, and remove plug from the socket-outlet.
AM
AM AUTO ON
AM AUTO
PM AUTO ON
AUTO ON
AUTO BLANK
AUTO OFF
OFF
OFF
OFF
OFF
C
C
C
C
MAX
MAX
MAX
MAX
 previous