Mellerware 35540 Electric Heater User Manual


  Open as PDF
of 6
 
OPERATION
1. Before using the heater make sure that it is on a
flat and stable surface. Damage may occur if it is
placed on an incline or decline.
2. Set all the controls to OFF position, and insert the
plug into a socket-outlet that is well grounded.
Be sure plug fits tightly into outlet. Be sure that
the main power switch is on before operating the
control panel.
3. Operation for control panel.
1.) SETTING THE CLOCK
Set the clock to the correct time before using the heater,
proceeding as follows:
Pressthebutton“hour”untilthedisplayshowsthe
hours for the correct time, then release the button.
Pressthebutton“minute”untilthedisplayshowsthe
minutes for the correct time, then release the button.
Whenever you want ot modify hours or minutes during
operation, just proceed as above.
NOTE: Do not modify the clock while the heater is
operating in auto mode. To activate the set time, you
mustreleasethebutton“hour”or“minute”foratleast
5 seconds.
2.) SETTING THE POWER
The variable power setting determines how fast the
desired temperature is reached. The higher the power
setting, the more energy is used.
NOTE:If you want to operate the appliance in manual
mode,pressthebutton“powersetting”toactivateit.
In this mode, the function of the booking timer will be
invalidated.
To set the required power level, proceed as follows:
pressthe“powersetting”buttononeormoretimes
within 5 seconds to select the power level, as per the
following sequence:
The power selecting can be circulated and the red
power pilot light will be on during the heater powered
on.
To cancel the manual mode, push the button “power
setting”untiltheLCDappear“OFF”,theredpowerpilot
light will be extinguished. Now the unit can be set in
auto mode.
3.) SETTING THE AMBIENT TEMPERATURE
Adjustthe“+”or“-“buttontothedesiredambient
temperaturefrom5to35˚Catanytimeduring
operation.Bypushingoncethe“+”or“-“button
the temperature (shown on the right side of the display)
willincreaseordecreaseby1˚C.Keepthebutton
pressed to move through the temperature in fast mode.
This heater has a sensitive temperature detector,
which automatically monitors the current ambient
temperature and switches the unit on to maintain your
chosen temperature.
If the selected temperature is higher than the actual
room temperature, the appliance will start automatically
and rapidly heat the room until it reaches the selected
temperature. The unit will automatically maintain the
temperature at a constant level.
4.) USING OF TIMER
The function of the time works only under the setting
manual mode setting. After the unit is powered on in the
manualmode,pressthebutton“timing”oneormore
times within 5 seconds to select the timing level, as per
the following sequence:
0:00h – 0:30h – 0:45h – 1:00h – 2:00h – 4:00h – 8:00h
The timing setting can be circulated as above sequence
and the timing pilot lamp light will be on during the
timing function activation. To cancel the timing, push
thebutton“timing”untiltheLCDappears“0:00h”or
pushthebutton“powersetting”untiltheLCDappears
“OFF”andwaitfor5seconds,theyellowtimingpilot
light will go out.
35
35
AM
Time Set
Temperature
AM
AM
AM
AM
MAXIMUM POWER
MINIMUM POWER OFF
MEDIUM POWER
OFF
C
C
C
C
C
MAX
MAX
MAX
MAX
MAX
8:00 35
AM
Time Set
Temperature
OFF
C
MAX
 previous next