Filter
Top Products
KEY TO THE VACUUM CLEANER'S
PARTS
1. Handle
2. Air valve
3. Telescopic tube
4. Parking system
5. Locking mechanism
6. Hose connector
7. Carrying handle
8. Vertical parking holder
9. Storage compartment for special
nozzles
10. Button for opening storage
compartment
11. Handle for opening dust bag
container
12. Exhaust grille
13. Handle for removal of exhaust grille
14. Start/stop button
15. Suction force regulation
16. Button for automatic cord rewind
17. Bag change indicator
18. Vertical parking holder
19. Automatic cord rewind
20. Floor nozzle
21. Brush change button
22. Extra nozzle for hard floors
23. Furniture nozzle
24. Joint nozzle
25. Brush nozzle
PREPARING THE VACUUM
CLEANER
• Fit the hose on the vacuum cleaner by
inserting the rotating hose connection
(6) into the vacuum cleaner until you
hear a click. To remove the hose, press
the button at the side of the hose
connection and pull it out.
• Fit the telescopic tube (3) into the other
end of the hose, and fit a floor nozzle
(20 or 21) to the end of the tube.
•You can adjust the length of the
telescopic tube by pushing the locking
mechanism (5) down and pulling in the
bottom section of the tube to a suitable
length. When parking, shorten the tube
as far as possible.
• The vacuum cleaner’s three special
nozzles (23, 24, 25) are kept in the
storage compartment (9), which is
opened by pressing the button (10).
Remove the floor nozzle and fit the
special nozzle required to the end of the
telescopic tube.
15
1.
2.
3.
4.
5.
6.
7.
9.
11.
12.
13.
14.
15.
16.
17.
18.
19.
10.
8.
20.
21.
22.
23.
24.
25.
VC-H5005_IM_rev 29/11/04 9:02 Side 15