Melissa 740-096 Vacuum Cleaner User Manual


 
KEY TO THE VACUUM CLEANER’S
PARTS
1. Floor nozzle
1a. Brush change button
2. Locking mechanism
3. Telescopic tube
4. Hose
5. Air valve
6. Handle
7. Hose connector
8. Dust container
9. Release button
10. Carrying handle
11. Button for automatic cord rewind
12. On/Off button
13. Button for controlling suction strength
14. Parking holder
15. Exhaust filter
16. Accessory store - 3 special nozzles
PREPARING THE VACUUM CLEANER
Attach the hose (4) to the vacuum cleaner by
inserting it into the hose connector (7) until
you hear a click. To remove the hose, press
the buttons at the side of the hose and pull it
out of the hose connector.
Fit the telescopic tube (3) into the other end
of the hose, and attach the floor nozzle (1) to
the end of the tube.
•You can adjust the length of the telescopic
tube by pushing the locking mechanism (2)
down and pulling on the bottom section of
the tube until it reaches a suitable length.
When parking, shorten the tube as far as
possible.
The three special nozzles are used for
particular vacuuming tasks, such as for
furniture, in the car, and so on. Detach the
floor nozzle and fit one of the special nozzles
to the end of the telescopic tube.
USE
Pull the cord out of the vacuum cleaner. The
cord must not be pulled out any further than
the red mark. Plug in and switch the power
on.
•Press the on/off button (12) to start and stop
the vacuum cleaner.
While in use, the suction strength can be
regulated by opening and closing the air
valve (5) on the handle at the end of the
hose.
The suction strength can also be adjusted
electronically using the button for controlling
suction strength (13). Suction strength
increases when the button is turned towards
"Max", and reduces when it is turned
towards "Min".
The floor nozzle has two settings. When
cleaning hard surfaces (parquet flooring,
flooring tiles, etc.), the nozzle brushes should
be extended. When cleaning carpets and
rugs, the brushes should be retracted into
the nozzle. Press the brush change button
(1a) to switch between the two settings.
15
1.
4.
2.
3.
1a.
5.6.
7.
8.
9.
10. 11.
12.
13.
14. 15.16.
740096_IM 25/08/05 9:42 Side 15