Filter
Top Products
OPERATION
- Do not remove the plug from the socket
by pulling the cable or the appliance
itself.
- Do not run the appliance over the
power cable.
- Do not use the appliance to vacuum up
lit matches, cigarette ends or hot ashes.
- Do not use the appliance on wet
surfaces.
- Do not obstruct the air intake or the air
outlet vents.
- Do not use the appliance to vacuum up
needles, drawing pins or string.
ASSEMBLING THE VACUUM CLEANER:
Fitting the tube:
- Press the buttons on the end of the
tube and insert the tube into the air-
intake.
Removing the hose:
- To release the hose, press the buttons
on the end of the hose and pull the
hose firmly from the air intake duct.
FLOOR BRUSH USE
- Press the button on the floor brush, so
the brush is shown for cleaning hard
floors
- Press the other button to withdraw the
brush for cleaning carpets.
INSTRUCTIONS FOR USE
- Before using the appliance, unwind a
sufficient length of cable and insert the
plug into the power socket. A yellow
mark on the power cable shows the
ideal cable length. Do not extend the
cable beyond the red mark.
To rewind the power cable, press the
rewind button with one hand, and guide
the cable with the other hand to ensure
that it does not whip causing damage.
- Press the ON/OFF button to switch the
appliance on.
- While in use, the suction strength can
be regulated by opening and closing the
air valve (5) on the handle at the end of
the hose.
- The suction strength can also be
adjusted electronically using the button
for controlling suction strength (13).
Suction strength increases when the
button is turned towards "Max", and
reduces when it is turned towards
"Min".
Adjustment of the telescopic tube
You can adjust the lenght of the telescopic
tube by holding the black ring and pulling or
pushing the part with the locking mecanism.
It can be unlocked just as easily and
brought into a different position.
REPLACING THE DUSTBAG:
After removing the hose, open the front
cover by pressing the lock lever and pulling
upwards.
Remove the dustbag-holder.
Remove the dustbag from the holder.
Replace the dustbag by inserting the carton
of the dustbag into the grooves of the
dustbag-holder.
REPLACING THE MOTORFILTER
The motor-filter is the filter placed behind
the dustbag:
Open the front cover, and gently pull out the
filter free of the holder.
Insert a new motor-filter.
REPLACING THE EXHAUST-
MICROFILTER
The exhaust-filter is the filter placed on the
back of the vacuum cleaner:
Press the release-button on the exhaust
grating and pull it out at the same time.
Remove the exhaust-filter and insert a new
exhaust-filter.
Insert the exhaust grating back in place.
15
640063_IM 24/10/05 10:21 Side 15