Filter
Top Products
- Do not use the appliance on wet
surfaces.
- Do not obstruct the air intake or the air
outlet vents.
- Do not use the appliance to vacuum
needles, drawing pins or string.
Telescopic tube
You can adjust the length of the telescopic
tube by pushing the locking mechanism
down and pulling in the bottom section of
the tube to a suitable length. When parking,
shorten the tube as far as possible.
ASSEMBLING THE VACUUM CLEANER:
Always remove the plug from the power
socket before fitting or removing
accessories.
Fitting the tube:
- Press the buttons on the end of the
tube and insert the tube into the air-
intake.
REMOVING THE HOSE:
Remove the plug from the power socket. To
release the hose, press the buttons on the
end of the hose and pull the hose firmly from
the air intake duct.
FLOOR BRUSH USE
- Press the button on the floor brush to
the back position so the brush is shown
for cleaning hard floors
-Press the button on the floor brush to
the back position for cleaning carpets.
INSTRUCTIONS FOR USE
- Before using the appliance, unwind a
sufficient length of cable and insert the
plug into the power socket. A yellow
mark on the power cable shows the
ideal cable length. Do not extend the
cable beyond the red mark.
-To rewind the power cable, press the
rewind button with one hand, and guide
the cable with the other hand to ensure
that it does not whip causing damage.
- Press the ON/OFF button to switch the
appliance on.
REPLACING THE DUSTBAG:
After removing the tube, open the front
cover by pressing the lock lever and pulling
upwards.
Remove the dustbag-holder by pulling the
handle of the holder.
Remove the dustbag from the holder.
Replace the filter by inserting the carton of
the filter into the grooves of the filter-holder.
REPLACING THE MOTORFILTER
- The motorfilter is the filter placed behind
the dustbag:
- Open the front cover, and gently pull out
the filter free of the holders.
- Insert a new motorfilter.
REPLACING THE MICROFILTER
The microfilter is the filter placed on the
back of the vacuum cleaner:
Press the release-button on the grid and
pull it out at the same time.
Remove the microfilter and insert a new
microfilter.
Insert the grid back in place.
EXTRA FEATURES
The cleaner has two wheels at the rear and
a multi-directional swivel wheel at the front
so that it can be moved easily. It also has a
convenient carrying handle.
Before storing your cleaner rewind the
supply cord. The cleaner may be stored
standing on its end, to save space.
The vacuum cleaner is fit with a carrying
strap, which makes it possible to carry the
vacuum cleaner around while vacuum
cleaning.
MAINTENANCE
Pull out the plug and if necessary clean the
appliance on the outside with a damp cloth.
Never immerse the appliance into water and
other liquids!
15
JCV-2007_tele_IM6 14/09/04 10:36 Side 15