Filter
Top Products
Low temperature burners - INDITHERM
®
www.maxoncorp.com
combustion systems for industry
MAXON reserves the right to alter specifications and data without prior notice.
© 2008 Copyright Maxon Corporation. All rights reserved.
1-2.3-9
E-m-7/08
Burner designation
Fuels
INDITHERM
®
burners are designed to operate on natural gas. For propane and butane operation a standard INDITHERM
®
burner can not be used. Contact MAXON when the use of gases other than natural gas is inevitable.
Burner discharge sleeve
The burner discharge sleeve is available in different materials and geometries:
Standard version with circular stainless steel discharge sleeve and square burner mounting plate.
High temperature version with refractory block for installation in applications where high temperatures can be expected.
In following cases the use of high temperature version discharge sleeve is required:
Dimension A is larger than 50mm
Insufficient low temperature process air is available to cool the discharge sleeve
No process air is available ( typical in indirect fired applications)
Process air is entered downstream of the burner, being unable to flow over the burner discharge sleeve
Burner type Burner size Burner gas connection Discharge sleeve Ignition Flame supervision
INDITHERM
®
300 ISO HTS DI UVC
Burner size
100
300
550
700
850
1100
1500
1800
Burner gas connection
ISO: ISO threated
NPT: NPT threaded
Discharge sleeve
HTS: High temperature
STD: standard version, stainless steel
Ignition
DI: Direct Ignition (plugged pilot port)
PL: Pilot burner
Flame supervision
UVC: prepared for UV-scanner mounting
FRC: prepared for flame rod mounting
Process air
A