Martin Fireplaces 400BWBCA Indoor Fireplace User Manual


 
61D0008 33
M1 M2
FAN
ASSEMBLIES
CORD SET
120V, 50HA
GROUND
TO FUSE
OR CIRCUIT
BREAKER
SWITCH
(SPST)
GLASS DOOR INSTALLATION
The model 400BWBCA, 400BWBCIA,
500BWBCA, and 500BWBCIA fireplaces may
be equipped with a Model FA2A fan accessory.
If the fireplace is to be equipped with the FA2A
fan at anytime, the junction box assembly must
be installed on the fireplace during fireplace
installation. See Figures 43 through 45. If
junction box is not installed at this time, wall
finishing materials must be removed to gain
access to the side of the fireplace to install
junction box later.
Note: A rectangular switch knockout is
provided on the lower right hand
face of the fireplace.
This fireplace has been tested and listed for use with optional Model GD36BA, BD36PBA, GD36SSA, GD42BA,
BD42PBA, and GD42SSA glass doors. For installation of glass doors, see the instructions provided with the doors.
FAN ACCESSORY
Figure 43 - Blower Location
Figure 44 - Blower Location (Side View)
Fan
(Faces Back of Fireplace)
Fireplace Bottom
Firebox
Bottom
Front of
Fireplace
Switch
Knock Out
Opening for
Fan Installation
Junction Box
Cover
Attach Each
Fan with Two
(2) Screws
Here
Figure 45 - Wiring Diagram