Filter
Top Products
THERAPY PUMP(S)
Allow the spa to circulate on high-speed (see Spa Side Controls) for 4-5 minutes to
discharge air from the plumbing system. Do not expect hot water immediately from
the jets; the heater will take several hours to heat the water.
Pr Diagnostic Message
NOTE: Coastal and Ultimate Series spas have a “pump priming” feature which begins
at start-up. When the spa is energized, the LCD panel will display a “Pr” message. This
mode will last approximately four to five minutes if not exited manually. To exit
manually, press the TEMP SET pad. At this time the spa should have water flowing
from the jets. If the pump has not primed and water
is not flowing from the jets after two minutes,
TURN OFF POWER TO THE SPA. Vent air
from the pumps by slightly opening the pump
unions (see TROUBLESHOOTING section, Water
Flow). After turning the power on again, the spa will
initiate a new priming mode. Repeat steps above.
After you have manually exited the priming mode (or
you allowed the spa to automatically exit) the LCD
display will momentarily display 102° F and then the
display will switch to - -° F. The system requires
approximately one minute of water flow to
determine the water temperature. After one minute of water flow, the temperature
will be displayed as actual water temperature F. Press the TEMP SET pad to adjust the
desired set temperature for the spa.
NOTE: Your spa has been filled and test-run at the factory. The first time your spa is
filled with water, some discoloration from residual test water may appear. This will
disappear when the spa is completely filled and the filtration system is functioning. Test
the water for the proper chemical balance and adjust as necessary. Marquis Spa Care
™
Products are recommended. PROPER CHEMICAL BALANCE IS IMPORTANT.
SAFETY ENERGY COVER
When the spa is not in use, the Safety Energy
Cover should be kept on the spa to retain the
water’s heat and to keep out dirt, leaves, etc. Your
heater will maintain a constant water temperature
between uses.
For your safety and convenience, the cover is
equipped with adjustable straps with safety locks.
Marquis suggests that you use them to help keep
out unintended users and prevent covers from
being blown off in windy conditions. For high wind
areas, Secure Straps are available. Duralift cover lifts
are also available to assist you in cover removal. See your Marquis Dealer.
OPERATING
YOUR SPA
page 14
ᮣ
ᮣ