Filter
Top Products
6
Clean out fine dust from prefilter. Next,
remove filter, and lightly tap to dislodge dust.
Reassembly
1
010070
Put on filter until it is fully in position on the
cleaner unit.
NOTE:
• Make sure filter is put on straight
without being peeled back. If filter is put
on incorrectly as shown in diagram,
dust will get into motor housing, and
cause motor failure.
1
010028
Connect prefilter. At this time, make sure to
twist prefilter so that securing lip is firmly
locked into cleaner unit.
1
2
010029
010030
Connect capsule. Align projection on
capsule with projection on handle and then
firmly twist capsule in direction of arrow until
it is secured.
010031
1
2
3
010032
NOTE:
•
Always remove dust ahead of time, as
suction power will be reduced if there is
too much dust in cleaner.
• Always be sure to check that both filter
and prefilter are loaded correctly prior to
using cleaner. If they are not loaded
correctly, dust will get into the motor
housing, and cause motor failure.
If the following examples occur, filter
and prefilter are not loaded correctly.
Reload them correctly to rectify
problem.
1. Capsule
2. Handle
3. Projection
1. Prefilter
2. Securing lip
1. Filter
1. Filter