Filter
Top Products
3
Primary Feature Operations (continued)
Override Operation: (Security system is Armed)
1. Enter the vehicle, the security systems will begin sounding at this point. Make sure that the switch is in the
OFF position.
2. Place the ignition key into the ignition switch and turn the ignition switch to the ON position.
3. Within 5 seconds of turning the ignition key ON, put the valet switch into the ON position.
4. The horn/siren will stop sounding.
5. The LED indicator will be solid red.
The security system is overridden and is now in the valet mode!
Valet Operation: (The security system is already disarmed)
1. Make sure that the switch is in the OFF position.
2. Turn the ignition key to the ON position.
3. Within 5 seconds of turning the ignition key ON, put the valet switch into the ON position.
4. The LED will be on solid indicating that the security system is in the valet mode.
Note 1: If the valet switch is already in the ON position when you turn ON the ignition key, the valet function will
be bypassed. Turn OFF the ignition key, set the switch to the OFF position and try again.
Note 2: If you fail to switch the valet switch into the ON position within 5 seconds of turning ON the ignition key,
the valet function will be locked out. Turn OFF the ignition key, set the switch to the OFF position and try again.
Starter Disable:
Your security system has a built-in starter interrupt relay that will break the connection between your ignition
key and the starter on your vehicle. To test this feature, repeat the following procedure:
1. Enter the vehicle and close all entrances.
2.
Press the LOCK button on your keyless entry transmitter to arm the security system and wait for 15 seconds.
3. Place the ignition key into the ignition switch and try to start the vehicle. The starter will not crank the
engine over.
4. Turn off the ignition key and press the UNLOCK button on your keyless entry transmitter to disarm the
security system.
5. Attempt to start the engine again. The starter will now engage and the engine will crank over and run.
Remote Panic:
The PL21 provides a remote panic function which allows the user to trigger the alarm by remote in the case of
an emergency.
1. Ignition key must be off.
2. Press the LOCK button 4 times.
3.The siren will begin to sound and the parking lights will begin to flash.
4. Press the UNLOCK button. The siren will stop sounding and the parking lights will stop flashing.
Note: If the panic function is not turned off by the transmitter, the siren will continue to sound for 60 seconds
and then turn off by itself.
Optional Features
C
hirp Delete:
The control module can be programmed by the dealer so there will be no arm/disarm status chirps. The multi-chirp
tamper disarm warning indicator will always be on for your safety.
Pathway Illumination:
If the pathway illumination function has been programmed on by your dealer your vehicles parking lights will illuminate
at the time the security system is disarmed by the remote transmitter. The parking lights will remain on for 30 seconds
after the security system is disarmed. Turing on the ignition key will turn off the parking lights before 30 seconds.
PL21-UM.qxp 4/28/05 16:36 Page 3