Lux Products T20-1141SA Thermostat User Manual


 
Attach wires to terminal screws shown in Figure 2. (Either wire to
either terminal) Push excess wire back into wall opening.
Find anticipator setting on old thermostat. Setting on new
thermostat should be the same. Do this by carefully sliding the
long pointer on the anticipator over the desired number. If old
anticipator setting cannot be determined, look on gas control on
furnace, or set it at .6. During heating season, furnace should
operate about five times an hour. If adjustments are necessary,
move heat anticipator pointer slightly and recheck. NOTE: Set
pointer to 1.2 for millivolt systems.
Attach front cover, Figure 1, to base.
Turn electricity and gas back on and set pointer on top of
thermostat to desired temperature.
A thermostat can only control temperature near it. If
you find that it is uncomfortable some distance away
from the thermostat, change the setting in order to
compensate for this.
UP
.2
.25
.3
.4
.5
.15
.12
L
O
N
G
E
R
C
Y
C
L
E
S
HOLES FOR WIRES
MOUNTING HOLE
ANTICIP
LONG
POINTER
CAPTIVE
SCREW
CAPTIVE
SCREW
MOUNTING
HOLE
ATOR
FIGURE 1 FRONT COVER
FIGURE 2 BASE
WARRANTY
TECHNICAL ASSISTANCE
FIGURE 3
DECORATIVE WALL PLATE
This product does not contain mercury. However, this
product may replace a unit which contains mercury and
should not be disposed of in the trash. Contact your local
waste management authority for proper disposal
instructions for mercury in a sealed glass tube. If you
have any questions, please call (856) 234-8803
RECYCLING
NOTICE
If you have any problems installing or using this thermostat,
please carefully and thoroughly review the instruction manual.
If you require assistance, please contact our Technical
Assistance Department at 856-234-8803 during regular
business hours between 8:00AM and 4:30PM Eastern
Standard Time, Monday through Friday. You can also receive
technical assistance online anytime day or night at
http://www.luxproducts.com. Our web site offers you answers
to the most common technical questions, and also permits you
to email your questions to our technical support staff at your
convenience.
Limited Warranty: If this unit fails because of defects in
materials or workmanship within three years of date of original
purchase, LUX Products Corporation will, at its option, repair
or replace it. This warranty does not cover damage by
accident, misuse, or failure to follow installation instructions.
Implied warranties are limited in duration to three years from
date of original purchase. Some states do not allow limitations
on how long an implied warranty lasts, so the above limitation
may not apply to you. Please return malfunctioning or defective
units to the participating retailer from which purchase was
made, along with proof of purchase. Please refer to
"TECHNICAL ASSISTANCE" before returning thermostat.
Purchaser assumes all risks and liability for incidental and
consequential damage resulting from installation and use of
this unit. Some states do not allow the exclusion of incidental
or consequential damages, so the above exclusion may not
apply to you. This warranty gives you specific legal rights and
you may also have other rights which vary from state to state.
Applicable in the U.S.A. only.