■■ Attach wires to terminal screws shown in Figure 2.
(Either wire to either terminal) Push excess wire back
into wall opening.
■■ Find anticipator setting on old thermostat. Setting on
new thermostat should be the same. Do this by
carefully sliding the long pointer on the anticipator over
the desired number. If old anticipator setting cannot be
determined, look on gas control on furnace, or set it at
.6. During heating season, furnace should operate
about five times an hour. If adjustments are necessary,
move heat anticipator pointer slightly and recheck.
NOTE: Set pointer to 1.2 for millivolt systems.
■■ Attach front cover, Figure 1, to base.
■■ Turn electricity and gas back on and set pointer on top
of thermostat to desired temperature.
A thermostat can only control temperature near
it. If you find that it is uncomfortable some
distance away from the thermostat, change the
setting in order to compensate for this.
UP
.2
.25
.3
.4
.5
.15
.12
L
O
N
G
E
R
C
Y
C
L
E
S
HOLES FOR WIRES
MOUNTING HOLE
ANTICIP
LONG
POINTER
CAPTIVE
SCREW
CAPTIVE
SCREW
MOUNTING
HOLE
ATOR
FIGURE 1 FRONT COVER
FIGURE 2 BASE
FIGURE 3 DECORATIVE WALL PLATE
This product does not contain mercury. However, this
product may replace a unit which contains mercury and
should not be disposed of in the trash. Contact your local
waste management authority for proper disposal
instructions for mercury in a sealed glass tube.
If you have any questions, please call (856) 234-8803
RECYCLING
NOTICE
If you have any problems installing or using this thermostat,
please carefully and thoroughly review the instruction
manual. If you require assistance, please contact our
Technical Assistance Department at 856-234-8803 during
regular business hours between 8:00AM and 4:30PM
Eastern Standard Time, Monday through Friday. You can
also receive technical assistance online anytime day or
night at http://www.luxproducts.com. Our web site offers
you answers to the most common technical questions, and
also permits you to email your questions to our technical
support staff at your convenience.
Limited Warranty: If this unit fails because of defects in
materials or workmanship within three years of date of
original purchase, LUX Products Corporation will, at its
option, repair or replace it. This warranty does not cover
damage by accident, misuse, or failure to follow installation
instructions. Implied warranties are limited in duration to
three years from date of original purchase. Some states do
not allow limitations on how long an implied warranty lasts,
so the above limitation may not apply to you. Please return
malfunctioning or defective units to the participating retailer
from which purchase was made, along with proof of
purchase. Please refer to "TECHNICAL ASSISTANCE"
before returning thermostat. Purchaser assumes all risks
and liability for incidental and consequential damage
resulting from installation and use of this unit. Some states
do not allow the exclusion of incidental or consequential
damages, so the above exclusion may not apply to you.
This warranty gives you specific legal rights and you may
also have other rights which vary from state to state.
Applicable in the U.S.A. only.
LUX PRODUCTS CORPORATION Mt. Laurel, New Jersey, 08054 USA
TECHNICAL ASSISTANCE
WARRANTY