Filter
Top Products
By default, this thermostat has 4 separate program periods for both Heat and
Cool mode, they are: MORN, DAY, EVE, and NITE. Each period ends at the start
time of the following period. The heat programs are set in HEAT mode, and the
cool programs are set in COOL mode.
NOTE: If the thermostat is configured to use only 2 periods per day instead of 4
(HARDWARE SETUP OPTIONS), the thermostat will only use the DAY and NITE
periods. The MORN and EVE periods will not be visible on the screen.
SET TEMPERATURE PROGRAMS: Move the Set Slide switch to the TEMP PROG
position. Programming will start with all 5 weekdays, Monday through Friday (all
grouped together). Use the UP/DOWN buttons to adjust the start time for the
MORN period, then press the NEXT button to advance. Use the UP/DOWN buttons
to adjust the set temperature for the MORN period, then press the NEXT button to
advance. Now adjust the start time and set temperature for the DAY period,
pressing the NEXT button after each to advance. Continue with these same steps
to adjust the start times and set temperatures for the EVE and NITE program
periods.
When the NITE period is finished for the weekdays, the thermostat will advance
forward to the Saturday program, with the MORN period start time flashing.
Perform the same steps that you used for setting the weekday periods, pressing
the NEXT button to advance through each flashing value.
When the Saturday NITE period is finished, the thermostat will advance forward
to the Sunday program, with the MORN period start time flashing. Perform the
same steps that you used for setting the Saturday periods, pressing the NEXT
button to advance through each flashing value. Return the Set Slide switch to
the RUN position when you are finished.
23
TEMPERATURE PROGRAMS: