Lux Products DMH100 Series Thermostat User Manual


  Open as PDF
of 3
 
2© COPYRIGHT 2004 LUX PRODUCTS CORPORATION. ALL RIGHTS RESERVED
4. Hold the base against the wall, with the wires coming
through wherever it is convenient for wiring. Route the
wires to below the terminal block. Position the base
for best appearance (to hide any marks from an old
thermostat). Attach the base to the wall with the two
screws provided.
CAUTION
Do not allow wires to touch each other or parts on thermostat. Wires must be
trapped between black spacer and brass terminal. Also, be sure to tighten
securely all 7 electrical terminal screws.
NOTE
If you are mounting the base to a soft material like plasterboard or if you are
using the old mounting holes, the screws may not hold. Drill a 3/16-in. (4.8mm)
hole at each screw location, and insert the plastic anchors provided.
Then mount the base as described below.
ATTACHING WIRES
WIRING DIAGRAMS
 previous