1
© 2014 LUX PRODUCTS CORPORATION. ALL RIGHTS RESERVED
I N S TA L L AT I O N A N D
O P E R AT I N G I N S T R U C T I O N S
Thank you for your confidence in our product. To obtain the best results from your investment, please read
these instructions and acquaint yourself with your purchase. Follow the installation procedures carefully, and
save these instructions for future reference.
This thermostat can be used with most single-stage 24 Volt hydronic, and radiant underfloor heating
applications up to 2 Amps. NOTE: this thermostat is system powered only, and requires 3 wires to the
thermostat location for operation: 24V+ Power, 24V- Common, and Heat Activation Signal.
This thermostat cannot be used with: 3-wire zone valves (non self-closing upon power removal), 120/240 volt
heating elements, cooling systems, or heat pumps. Ask your dealer for other LUXPRO thermostats to control
those systems.
• The electrical rating for this thermostat is 2.0 Amps.
• The thermostat contains parts that may wear out through use and are susceptible to failure if over-loaded or
used in a manner other than as indicated in the documentation.
• Check unoccupied residences regularly to ensure that all systems are operating properly.
• Check any heating/air-conditioning system including this product before operation and at regular intervals.
• Electrical interference, static electricity, failure or substandard performance of batteries, wiring defects in
the installation and/or characteristics of the connected HVAC devices may prevent the system from
regulating heating and cooling as anticipated.
• The thermostat is a sensitive device and dropping the product can cause damage to critical components. If
the product is dropped or shaken violently during transport or installation then it should be replaced
immediately.
• Persons with physical or mental limitations may not be able to promptly respond to a malfunction of the
heating/air-conditioning system.
• All residents should be made aware of the potential in any system for malfunctions that could cause
continuous heating or cooling and should be familiar with the operation and location of the heating/cooling
appliance on/off switch.
• Read the instruction manual completely before installing the thermostat.
Radiant Floor/Slab Heating Only
Thermostat with Remote Sensor (included)
P 2 0 0 0 F
5
2167
LUX Products Corporation - Mt. Laurel, New Jersey 08054 - http://www.luxproproducts.com
SYSTEM COMPATIBILITY:
CAUTIONS AND WARNINGS: