Filter
Top Products
10 Stove Installation (for qualified installers only)
© Travis Industries 100-01177_005 4100818
Bypass Handle Installation
The bypass handle is shipped inside the owner’s pack (along with a 1/8” hex wrench). With the set
screws loosened, line up the bypass handle with the bypass rod (Figure 4). Press back on the bypass
lever and slide the handle into place. NOTE: Several washers may be included on the bypass rod to
act as spacers – do not remove these washers
. Once in place, secure the handle by tightening the
two set screws. Make sure the set screws are properly located over the holes in the bypass rod. When
tightened, the set screws will submerge below the surface of the handle (Figure 4).
Figure 4
Rear Vent Configuration
The rear vent configuration is only for masonry fireplace installations (hearth stove). All steel chimney
applications require the top vent configuration.
The vent (chimney connector) may be directed to the rear of the appliance when installed into a masonry
fireplace. See Figure 5 for details.
The flue collar is held in place with three bolts
and two nuts. Use two 7/16" open-end
wrenches to remove the bolts and nuts.
7/16" Wrench
NOTE: Make sure the gasket
underneath the flue collar is properly
located and seals the flue collar when
it is installed.
Open the bypass - this
allows for access to the
nut under the flue collar.
Remove the flue collar and rotate it to the rear.
Use the exiting bolts and nuts to attach the
sides of the flue. For the center connection
use the bolt and acorn nut included in the
owner's pack.
Figure 5