Filter
Top Products
46
(9) To change the airfl ow direction not to blow directly onto your body. (MSZ-A09/12/15/17, MSY-A15/17)
To change the airfl ow direc-
tion
When to use this function? COOL/DRY
HEAT
(For MSZ)
Pressing and holding VANE
CONTROL button for 2
seconds or more cause the
horizontal vane to reverse
and move to horizontal posi-
tion.
Use this function if you don’
t want the air from the indoor
unit to blow directly onto your
body.
• Depending on the shape of
the room, the air may blow
directly onto your body.
• Press VANE CONTROL
button again to return the
vane to the previously-set
position.
The air conditioner starts
the cooling or drying opera-
tion approx. 3 minutes after
the vane has moved to the
horizontal position.
• When VANE CONTROL
button is pressed again,
the vane returns to the
previously-set position and
the air conditioner starts
the cool or dry operation in
approx. 3 minutes.
The air conditioner starts heating
operation approx. 3 minutes after
the vane has moved to the horizon-
tal position.
• Sometimes the area around your
feet may not warm. To warm the
area around the feet, set the hori-
zontal vane to
(AUTO) or the
downward-blowing position.
• When VANE CONTROL button is
pressed again, the vane returns
to the previously-set position and
the air conditioner starts the heat
operation in approx. 3 minutes.
NOTE :
• If you make the airfl ow not to blow directly onto your body by pressing VANE CONTROL button, the compressor stops for 3
minutes even during the operation of the air conditioner.
• The air conditioner operates with Very Low speed until the compressor turns on again.
Horizontal
position
(
10
) ECONO COOL ( ) operation (ECONOmical operation)
When ECONO COOL button is pressed in COOL mode, set temperature is automatically set 3.6°F higher than that in
COOL mode.
Also the horizontal vane swings in various cycle.
SWING operation makes you feel cooler than set temperature. So, even though the set temperature is higher than that
in COOL mode, the air conditioner can keep comfort. As a result, energy can be saved.
ECONO COOL operation is cancelled when ECONO COOL button is pressed once again or VANE CONTROL button is
pressed or change to other operation mode.
(
11
) POWERFUL ( ) operation
The air conditioner automatically adjusts the fan speed and the set temperature, and operates the POWERFUL mode.
The POWERFUL mode is automatically released 15 minutes after operation starts, and the operation mode returns to
the mode prior to POWERFUL operation.
61
23
45SWING
2. Vertical vane (MSZ-A24, MSY-A24)
(1) Vane motor drive
These models are equipped with a stepping motor for the vertical vane. The rotating direction, speed, and angle of the
motor are controlled by pulse signals (approx. 12 V) transmitted from microprocessor.
(2) The vertical vane angle and mode change as follows by pressing WIDE VANE button.
(3) Positioning
The vane is once pressed to the vane stopper to confirm the standard position and then set to the desired angle.
Confirming of standard position is performed in the following cases.
(a) When OPERATE/STOP (ON/OFF) button is pressed (POWER ON/OFF).
(b) When SWING is started or finished.
(c) When the power supply turns ON.
(4) SWING MODE (
)
By selecting SWING mode with WIDE VANE button, the vertical vane swings horizontally.
The remote controller displays “ ”.