Linear AM-KP Door User Manual


  Open as PDF
of 2
 
INSTR, AM/II-KP
Linear P/N: 211560 D
Material: 20 Lb. Mead Bond
Size: 8.500" x 11.000"
Ink: Black
Scale: 1-1
Side 2 of 2
5. CONNECT CABLE 6. SET DEVICE ADDRESS 7. SECURE & LOCK CASE
8. PROGRAM SYSTEM 9. TEST KEYPAD LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship for twelve
(12) months. The Warranty Expiration Date is labeled on the product.
This warranty
extends only to wholesale customers
who buy direct from Linear or through Linear’s
normal distribution channels.
Linear does not warrant this product to consumers.
Consumers should inquire from their selling dealer as to the nature of the dealer’s
warranty, if any.
There are no obligations or liabilities on the part of Linear
corporation for consequential damages arising out of or in connection with use
or performance of this product or other indirect damages with respect to loss of
property, revenue, or profit, or cost of removal, installation, or reinstallation.
All
implied warranties, including implied warranties for merchantability and implied
warranties for fitness, are valid only until Warranty Expiration Date as labeled on the
product.
This Linear Corporation Warranty is in lieu of all other warranties express
or implied.
All products returned for warranty service require a Return Product Authorization
Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA#
and other important details.
Copyright © 2000 Linear Corporation 211560 D
FOR LOCAL POWER, DISCONNECT RED WIRE FROM "PWR" CONNECTION
ON AM-KP AND CONNECT EXTERNAL 12 VDC SUPPLY (+ TO PWR & - TO GND)
NOTE: AM/II MUST BE CONNECTED TO AM-KP "GND"
B
O
1
O
O
O
1
1
1
B
B
O
1
KEYPAD IN
PWR GND
DAT1
DAT0
DVAL
CLK
AM/II
AM-KP
GRN
BLK
WHT
BLU
ORG/YEL
RED
USE A SMALL SCREWDRIVER
TO SET THE DEVICE ADDRESS SWITCH
EACH REMOTE DEVICE
MUST BE SET TO A
UNIQUE NUMBER
FROM 1 TO 6
ARROW ON SLOT
POINTS TO NUMBER
HOOK KEYPAD
ONTO BACKPLATE
USE KEY TO
LOCK KEYPAD
P R O G R A M T H E A M /II
TO CONFIGURE THE KEYPAD(S)
AND SET THE ENTRY CODES
REFER TO THE AM/II
PROGRAMMING INSTRUCTIONS
FOR DETAILS
*
5
6
7
8
9
0
#
1
2
3
4
RED INDICATOR SHOULD
BE LIT
ENTER VALID CODE
RED INDICATOR SHOULD
TURN GREEN AND PROGRAMMED
R E L A Y IN A M /II
S H O U L D A C T IV A T E
1.
2.
3.
YELLOW INDICATOR LIGHTS
W HEN KEYPAD IS LOCKED OUT
OR BUSY
 previous