Filter
Top Products
525 Education Road, Cornwall K6H 6C7
Tel:(613)938-6221 Fax:(613)938-0961
Page 2
Rev.01
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTIONS FOR INSTALLATION OF AGILI-T FIXTURES
This fixture is intended for installation in accordance with the National Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector
before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
SH20330
Page 2 0f 2
4. Place end-caps at luminaire extremities (Figure 6)
or connect next luminaire in row (Figure 7).
5. Secure end-caps or next luminaire in row by
tightnening two screw wedges (Figure 6-7) of
aluminum joiner (Figure 4).
End-Caps
Luminaire 1
Luminaire 2
Figure 6
Figure 7
Screw Wedge
Screw Wedge
6. Locate Junction Box on mounting clip using lancings (Figure
8) and secure from inside with #8 screw provided. Pull power
feed wire through bushing into J-Box, secure with strain relief
and make electrical connections (Figure 9).
7. Install J-Box cover using #8 screw provided and secure J-Box
to building structure as per local building codes (Figure 10).
8. Notch (1-1/2" x 1-1/2" max) and place tile (Figure 11).
9. Secure canopy using set screw provided (Figure 11).
#8 Screw
J-Box Cover
Mounting Clip
Strain Relief
Figure 8
Figure 9
Lancing
#8 Screw
Junction Box
Set Screw
Support to Building
Structure
Figure 10
Figure 11
Canopy
Bushing
Power Feed
Tile