Filter
Top Products
525 Education Road, Cornwall K6H 6C7
Tel:(613)938-6221 Fax:(613)938-0961
Page 1
Rev.01
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTIONS FOR INSTALLATION OF AGILI-T FIXTURES
This fixture is intended for installation in accordance with the National Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector
before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
SH20330
Page 1 0f 2
1. Install mounting clip on T-Bar (Figure 1) and insert canopy onto suspension kit (Figure
2). Fasten Power Feed Suspension Kit or regular Suspension Kit to 1/4-20 screw
provided (Figure 2). Attach clips to upper deck when required by local code by inserting
support to building structure through the supplied holes (Figure 3).
T-Bar
Mounting Clip
Suspension Kit
Support to Building
Structure
Figure 1
Figure 2
Figure 3
Figure 4
Aluminum
Joiner
Power Feed
Connection
2. Install luminaire temporarily by inserting die-cast aluminum joiner mechanism at the end of aircraft cables (Figure 5).
into plastic end cap of fixture (Figure 4). Manually plug in power feed connection (plus 2 extra communication cables for
Agili-T Network) when installing single luminare or first of a row (Figure 5).
3. Adjust height using aircraft cable plunger mechanism (Figure 5). Adjust level by sliding Aluminum Joiner sideways as
needed (Figure 4). Final level adjustment can be performed before or after installing end-cap or next luminaire in a row.
Plunger
Mechanism
Figure 5
Aircraft Cable
Canopy
1/4-20 Screw
Plastic End Cap