Lightolier IS:LLACSW Indoor Furnishings User Manual


  Open as PDF
of 2
 
E. DAISY CHAIN INSTALLATION: (Fig.13)
Note: Use 3/8 in. flexible metal conduit only.
1. Remove connection cover plate.
2. Loosen bushing and cord.
3. Remove knock-out from the large hole.
Note: For continuous daisy chain, other knock-out and cord
must be removed.
4. Insert red sleeve on BX cable.
5. Snap 3/8 in. connector into cover plate hole(s).
6. Connect the green wires to ground the fixture.
7. Connect the white (NEUTRAL) wires together.
8. Connect the black (120V) wires together.
9. Reinstall cover plate with 2 screws.
F. 4-BUTTON CONTROLLER:
Note: Control buttons display are touch-sensitive. Touch centre of pictogram. A
audible beep confirms new selection.
PRESET ( ): (Fig. 14)
a) One-touch selection changes preset up or down .
b) Hold any selection to scroll between presets in a continuous loop hold preset
Note: For more details on PRESET, see PRESET sheet.
BRIGHTNESS ( / ): (Fig.14)
a) One-touch selection increases/reduces brightness level by 5%.
b) Hold setting to dim up/down in 5% increments every 1/5 second.
G. FOR DMX CONTROL:
1. Simply connect data cable (shielded cats recommended) into DMX connector
RJ45e jack. (Fig.15)
2. For daisy chain data connection, connect data cable cat into data-in socket of
the first luminaire, then connect the data cable to the data-out connector jack of
the next luminaire and so on. (Fig.16)
3. For signal termination, connect a DMX signal terminator to the data out of the
last luminaire in the network. (sold separately). (Fig.17)
Note: Hardware required for DMX control system: (not supplied)
Controller: DMX512 protocol.
Wiring: Use low-capacitance shielded twisted-pair stranded cables such as
EIA485 (RS485) or shielded CAT#5e.
- 24AWG: maximum run length of 300 m (1000 ft).
- 22AWG: maximum run length of 500 m (1600 ft).
Note: Using unshielded cable may create noise in the system and may cause
undesirable light output.
Connectors: RJ45e connector – 8 conductors (connections: T568B).
FIG.12
FIG.13
FIG.14
FIG.15
FIG.16
FIG.17
SCREW
COVER PLATE
SCREW
CORD
BUSHING
CONNECTOR
BX
CABLE
SLEEVE
PICTOGRAM
RECEPTACLE
RJ45e
JACK
RECEPTACLE
RJ45e
JACK
DMX
TERMINATOR
ANCHOR
OBLONG HOLES
DATA-IN
DATA-OUT
Lightolier is a Philips group brand
IS:LL ACSW
Page 2 of 2 10-08/Rev-01
 previous