Filter
Top Products
© 1997
INSTRUCTION SHEET NO.
IS:7586
B1197 Page 2 of 2
B. MOUNTING TRACK ONTO STEMS
1. Loosen Screws on Track Clamps. In the stem used for power feed,
the Track Clamps must be positioned as shown in Fig. 2.
Place Track Ribs (Fig. 4) between Track Clamps and side track into
position. Make sure Bead (Basic and Advent only) (Fig. 4) of Track
Units are in line with one another.
2. Run Supply Leads along top of track toward Live End. Loosen screw
in Live End and remove from track.
3. Cut Wireway Cover to distance from Track Clamp to end of Track
Unit. Slide Wireway Cover into track over Supply Leads (Fig. 2 and
4).
For ProSpec Feed track, place wire cover into track before
attaching the stems to the track unit.
4. Remove Bottom Cover from Live End.
5. Break off Barrier in Live End by bending it back and forth (Fig. 3).
6. Pass Supply Leads through barrier opening in Live End. Insert Live
End into Track Unit and tighten Screws (Fig. 2 and 3).
7. Connect Supply Leads to screw terminals as shown in Instruction
Sheet IS:6020, IS:6121, for Advent), or IS:26000, IS:26046, IS:26050
for ProSpec. Ground terminal in Live End is not used when feeding
power from a Stem.
8. Fasten Bottom Cover to Live End. Tighten Screws on all Track
Clamps.
C. Instructions for Stem Extension Kit
1. Screw Coupling to threaded end of Stem (18" or 48" long) supplied
with Stem Mounting Kit (fig. 5).
2. Screw Stem supplied with Stem Extension Kit to Coupling (Fig. 5).
3. Complete installation of Stem Mounted Lytespan Track following
steps in section A and B.
Installation Instructions for Stem Mounting Kit
for use with Lytespan and ProSpec
™
Track Systems Only.
Basic Track
Wireway Cover
Track Rib
Bead
Individual
Track Unit
Screw
Sidewall
Bottom Cover
Live End
Advent Track
Center Barrier
Fig. 4
Fig. 4
Track Clamps
Screws
Stem
(Stem Mounting Kit)
Supply Leads
Coupling
Screw Collar
Canopy
Set Screws
Stem Mounting
Plate
Fig. 3
ProSpec Track
Wireway Cover Track Rib
Bead
Wireway Cover
Track Rib
Feed Track
Barrier
Barrier