Filter
Top Products
*
-
INSTRUCTION SHEET NO.
1s:6079
INSTALLATION FOR AITACHING EXTENSION WAND SLOPED
CEILINGS ADAPTER TO LYTESPAN TRACK. FOR USE WITH
0493 Page 2of 2
LYTESPAN@ TRACK SYSTEMS ONLY (Continued)
INSTRUCTIONSFORAllACHING LYTESPOV FIXTURESWITHSQUATADAPTERTO WANDSLOPEDCEILINGADAPTER
1. InserttheFIXTUREFllllNG intotheWANDSOCKET.
TheLOCKINGLEVERmustbeonthesamesideasthebeadlocatedatthebottomofthewand(SaaFig.9.)RotatetheFIXTUREFITTING90°clockwise
untilLOCKINGLEVERsnapsandlocksintoplace.(SeeFig.9,10,&11).
2.
To remove, depress LOCKING LEVER and rotate FllllNG 90° counterdockvke,
=f&icL- ‘Go kFIG.ll
INSTRUCTIONS FOR AllACHING
LOW VOLTAGE LYTESPO~ TO WAND SLOPED CEILING ADAPTER
1, Insertthe FIXTURE FllllNG intothe WAND SOCKET.
The LOCKING LEVER must be on the same side as the bead located at the bottomof the WAND SOCKET (See Fig. 8.) Rotate the FIXTURE
FllllNG 90° clockwise. (See Fig. 12, 13, & 14).
2, To remove, rotate FITTING 90° counterclockwise.
WAND
SOCKET
n
(--’
r--?
%
BEAO
FIXTURE
~
FITTING
LCCKING-
LEVER
CLOCKWISE
\
@
/’
t~
1
\ \
FIG. 12
FIG. 13
FIG. 14
INSTRUCTIONS FOR A~ACHING LYTESPOT WITH “T” ADAPTOR TO WAND SLOPED CEILING ADAPTER
1. Align BEAD on WAND SOCKET with GROOVE in FITTING before inserting into WAND SOCKET, see Fig. 15. (If BEAD is
NOT aligned
a potentialhazard may result.)
2, PoshionLEVER as shown inFig. 15.
3. InsertFllllNG intoWAND SOCKET, Turn LEVER 90° to make mechanical and electrical connection,See Fig. 16.
4, To remove reverse procedure.
NOTE: If “T” ADAPTOR has a full gasket on top, remove 1/2” strip of cork between contact hub and grounding spring, If there is no
gasket, and a tighter fti to the WAND is desired, remove backing from enclosed GASKET. When centered on FllllNG apply pressure
on GASKET to secure it.
CONTACTHUB
WANO
SCCKET
-._—————
GROUNDINGSPRING
BEAD _
REMOVECORKAND
PAINT(IFPRESENT)
$ “ ‘4
~~- - GRouND, ‘:-~ ‘WK
FROMTHISAREA
TOINSUREPROPER
GASKET ~
GROOVE
1
\
RELEASE
LEVER
FllllNG
FIG. 15
FIG. 16
FIG. 17