Lightolier IS:40712 Indoor Furnishings User Manual


  Open as PDF
of 2
 
WTRlfCTfON SHEET NO.
S:40712
INSTRUCTIONS FOR INSTALLATION OF
RADIANCE PENDANT FIXTURES CONTINUED
!92 Page 2 of 2
JSPENSION CABLE Attachment AND ADJUSTMENT
1.
Loosen (do not remove) fhe BATTERY NUTS tha! secure WIREWAY COVERS on each of the three SUPPORT ARMS (Fig. 2 and 3A),
2, Slide each WIREWAY COVER inward towards the renter of the fixiure (Fig, 3A),
3. Position SUSPENSION CABLES through the SLOTS in the end of
WIREWAYCOVERS(Fig,3B},
4. SifdeeachWIREWAYCOVERoutwardfromthecanterofthe
fixiure untilSUSPENSIONCABLEistau[,Securein position by tightening
BA~ERY NUTS (Fig. 3C).
5. Install recommended lamps by snapping base of lamp into SOCKET and allowing tip of lamp 10rest
on LAMP SUPPORT BRACKET (Fig, 2),
IFFUSER CLEANING AND REMOVAL
CAUTION Turn power off to fixture before anempting to dean.
CMfusercan be cleaned from above the fixture by removing lamps and cleaning DIFFUSER with a soft damp cloth, Should
DIFFUSERneedtobe
removedforcleaning,followstepsbelow,
1.
2.
3.
Removelampsfromfixlure,
Frombefowfixture,pushup on one side of the DIFFUSER and allow the opposite to drop down passed HOLOER KNOB (Fig. 1)
Side OIFFUSER out on an angle from LOWER FIXTURE ASSEMBLY
NOTEOIFFUSERmayhaveFObegentlycompressedoneitherside 10pass through opening in LOWER FIXTURE ASSEMBLY.
SUPPORTARM
.-
WIREWAYCOVER
BA~ERY NUT
))
BATTERYNUT >
B
WIREWAYCOVER-J’
/d
SUPPORTARM
FfG.3
 previous