Filter
Top Products
1s1155
IN!YCALLATION OF ADJUSTABLE ACCENT LIGHT (LOW VOLTAGE TRIM)
R0487
6. Remove lAMPHOLDER RING from within HOUSING
by pulling straight down, and disengaging ths LAMP
SPRINGS which also act se a holding mechanism for
lAMPHOLDER RING.
7. Select voltage (12v., 25-50 Watt, or 5.5v, 25 Watt)
depending on lamp being used? by setting SLIDE
SWITCH (Fig. J). Insert screwdriver into slot and slide
switch if not already set according to lamp being
used (See Fig. K).
swHG-
LAMP HOLDER -
SUPPORT
LAMP >
CONNECTOR
w
HOUSING
8. Install proper wattage PAR36 LAMP into IAMP
CONNECTOR, making certain the LAMP is seated all
the way into the IAMP CONNECTOR.
LAMP=------
9. Insert LAMP into LAMPHOLDER RINGS so that face
of LAMP is seated, and extended through hole in the
LAMPHOLDER RING, and put the lamp and ring
back into the LAMPHOLDER SUPPORT so that the
LAMP SPRINGS now support all.
LAMP HOLDER ~
RING
ti~.
FIG. J
Q
\H “\-
\.
\
A
/“
. ...
...’
FIG. K
m4srALumor4 OF
EVEBALL (mw VOLTAGE TRIM)
6. Remove APERTURE TRIM from within EYEBALL by
pullin straight down, and disengaging from
SUPP?)RT SPRINGS (Fig. L).
7. Select voltage (12v.,25-50 Watt, or 5.5v, 25 Watt)
depending on lamp being used! by eetting SLIDE
SWITCH (Fig. L). Insert screwdrwer into slot and slide
switch if not alreedy set according to lamp being
used (See Fig. K).
6. Install proper wattage PAR36 LAMP into LAMP
CONNECTOR, meidng certain the LAMP ia seated all
the way into the IAMP CONNECTOR (Fig, L).
9. Insert LAMP into LAMP SPRING.
10, Insert APERTURE TRIM, and LAMP into EYESALL
until groovee on APERTURE TRIM engage into
SUPPORT SPRINGS [FiO. L).
NOTE LOW VOLTAGE &i+lJRE6 should be
dimmed only with speclel dimmers Mended for
that purpose. Use Ughtoller Preolslon LV, Eoeniet,
or Lytemcds, or equlvelerrt products
~others or
vsrieble eutc-transformers or eleotrcn c dimmers
intended for uee with low voltege flsturss.
NOTE law voltege flstures may produce sudible
sound when used with externel dimme~ which mey
be objectlonsl In acoustically critlcsl srea%
SLID
co
FIG. L
WARNING USE ONLY REFLECIOR TRIMS PROVIDED SV LIGHTDLIER INC. USE OF ~HER MANUFACTURERS
REFLECIUR TRIMS VOIDS THE UNDERWRITERS IABOFIA30RIES L16TING AND COULD CONSIWIJTE A FIRE
HAZARD.