Lightolier IS:1102P1 Indoor Furnishings User Manual


  Open as PDF
of 2
 
1. CUT OPENING (FIG. A)
Use MOUNTING FRAME opening as template.
2. WIRE-IN (FIG. B)
Wire to supply leads. (Use built-In Cable Clamp in J-Box for non-
metallic sheathed cable (Romex) or armored cable (BX)).
3. PUT THROUGH (FIG. C)
a. Remove ADJUSTABLE MOUNTING BARS.
b. Break off BRIDGE on MOUNTING FRAME as shown in FIG. G
(break WEBS on SLOTS with cutting plier).
c. Pass MOUNTING FRAME into CEILING as shown.
4. ANCHOR (FIG. D)
a. Using NAIL CLIPS, (order separately; Cat. #1985N for 1002
Frame-In Kit, Cat. #1985S for 1102 Frame-In Kit).
5. SNAP-ON (FIG. E)
6. PUSH-UP (FIG. F)
INSTRUCTION SHEET NO.
IS:1102P1
A0403 Page 2 of 2
INSTALLATION PROCEDURE FOR FRAME-IN KITS
1002P1 & 1102P1 EXISTING CONSTRUCTION
®
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
WARNING-USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER INC. USE OF OTHER MANUFACTUR-
ERS’ REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE
A FIRE HAZARD.
SEE SEPARATE REFLECTOR TRIM
INSTRUCTION SHEETS.
FIG. A
1. CUT-OPEN
FIG. B
2. WIRE-IN
FIG. C
3. PUT THRU
FIG. D
4. ANCHOR
FIG. E
5. SNAP-ON
FIG. F
6. PUSH-UP
 previous