Lightolier IS:1062LV Indoor Furnishings User Manual


  Open as PDF
of 2
 
INSTRUCTION SHEET NO.
IS: I062LV
0192 Page 2 of 2
LAMPING
1.Checkto sea that poweris OFF before Iampingor relamping.
2. Removebaffle aperturefrom ELBOWby pullingstraightout (Fig.H).
3. Insertlamp (MR-16bulb) between lampsprings.
4. Attach SOCKETto hi-pin prongson LAMP.
5. InsertLAMP RINGwith LAMP and GLASS LAMP GUARD back into ELBOW.
WARNING:
A. LAMPMANUFACTURERSREQUIRETHEGLASS
LAMPGUARDBEIN PLACE
BEFOREENERGIZINGLAMP, AND THAT GREAT CARE MUSTBE TAKEN
THAT LAMP IS FULLY COOLED BEFORE RELAMPING. AVOID FINGER
MARKSON INSIDEOFLAMP FORTHEYMAYCAUSESHORT LAMPLIFEAND
POSSIBLE BREAKAGE.
B.USE ONLY REFLECTORTRIMS PROVIDEDBY LIGHTOLIERINC. USE OF
OTHERMANUFACTURER’SREFLECTORTRIMSVOIDSTHEUNDERWRfTERS
LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.
w“T ““p
\
L
GIASS LAMP
GUARD
~ BAFFLE
Fig. H
APERTURE
NOTE:
1. LOW VOLTAGE FIXTURES should be dimmed only by specialdimmers intended specifically for that purpose. Use Lightolier,
Scenist, Crescendo VA, Neptune VA, Precision VA
EasysetVA,Sunrise VA, Radiant VA, or equivalent products by others or
variable autotransformers or electronic dimmers intended for use with low voltage fixtures.
2. Low voltage fixtures may produce audible sound when used with dimmers, which maybe objectionable in acoustically critical areas.
JUNCTIONBOX
I_
[
TRANSFORMER
PRIMARY120V.60
Hz
SECONDARY11.4V.
&5W.LOAO
Wwl
II
II
3 21/32’
I
+—---- 5 29/32’ FIANGE DIA.—--+
Fig. I
—
.-
 previous