Lightolier IS:1062LV Indoor Furnishings User Manual


  Open as PDF
of 2
 
WARNING: BEFORE INSTALLING REFLECTOR TRIM FRAME4N
KIT, READ MARKINGS IN REFLECTOR TRIM AND ON SOCKET CUP
OF FRAME-IN KIT TO DETERMINE LAMP WAllAGE AND TYPE
APPLICABLE FOR YOUR INSTALLATION. IF I.C. TYPE FRAME-IN KIT
IS USED, IT MAYBE INSTALLED IN DIRECT CONTACT WITH
INSULATED CEILING. IFA NON LC.TYPE FRAME-IN KIT IS USED, DO
NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR
WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER
TO ENTRAP HEAT.
w
Y
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALUNG FtXTURE
INSTRUCTION SHEET NO.
This fixture is intendedfor installationin accordancewith the NationalElectricalCode and local
regulations.Toassurefull compliancewithlocalcafes andregulations,checkwithyourlocalelectrical
inspectorbeforeinstallation.Topreventelectricalshock,turnoff electricityatfuseboxbeforeproceeding.
IS:1062LV
Retain these instructions for maintenance reference.
0192 Page 1 of 2
INSTRUCTIONS FOR INSTALLATION OF REFLECTOR TRIM 1062LV
IN THE 10OOLV FRAME- IN-KIT
?? s
Fig. A Fig. B Fig. C
Fig. D
1. FRAME-IN
2. CLOSE-IN
3. SNAP-ON
4. PUSH-UP
FRAM-INKIT MOUNTS
FLUSHONCEIUNG
.,. ... :.,- ....
ROTO-CUP
1.FRAME-IN (Fig. A)
POSITION
See Frame-InInstructionSheetfor installationprocedure.
2, ROTATEROTO-CLIPS(Fig. B)
Fig. E
As shown in Fig. E.
3, SNAP-ON (Fig. C)
RECTANGLEHOLE
lnsertSOCKETthrough RECTANGLEHOLEontopof REFLECTORTRIM.
EngageTAB from SOCKETCUP into one ofthe SLOTSon top of
REFLECTORTRIM and push other end of SOCKETCUP with LANCING
into the other (Fig. F).
4. PUSH-UP(Fig. D)
PushREFLECTORTRIM intoceilinguntilflange isflushto ceiling(Fig.D).
SLOTS
TRIM
\l (
NOTE: Socket manufacturers have suggested that socket may fail after
3 to 6 relampings. If this occurs, socket can be replaced by disconnect
SOCKET
ing male connectors (attached to socket leads) and female connectors
(attached to fixture leads) and replacing it with a new socket procured
through LIGHTOLIER (Fig, G).
Fig. F
INSULATINGSLEEVING MALECONNECTORS(AllACHED TO SOCKETWIRE)
FEMALECONNECTORS(ATTACHEDTO FIXTUREWIRES)
- ~@MR’’”KH
SEE BACK PAGE FORIAMPING INSTRUCTIONS
Fig. G
1. I es
l“ITC>1.1E R“
i%%wyi!liwn