Filter
Top Products
LAMPING INSTRUCTIONS AND ADJUSTMENTILOCKING
INSTALL LAMP
5.
6.
7.
s.
Remove LAMP RING from LAMPIYOKE HOLDER by
pulling straight down (Fig. H).
insert LAMP (MR-16) between LAMP SPRINGS until
face of LAMP sits firmly on GLASS LAMP GUARD
(Fig, l).
Attach SOCKET to hi-in prongs on LAMP (Fig. l).
Insert LAMP RING with LAMP and GLASS LAMP
GUARD attached back into LAMP/YOKE HOLDER
(Fig. J).
~
WARNING: LAMP MANUFACTURERS REQUIRE THE
GLASS IAMP GUARD BE IN PLACE BEFORE ENERGIZING
LAMP AND THAT GREAT CARE MUST BE TAKEN THAT
LAMP IS FULLY COOLED BEFORE RELAMPING. AVOID
FINGER MARKS WHEN HANDLING FOR THEY MAY CAUSE
SHORT LAMP LIFE AND POSSIBLE BREAKAGE.
VERTICAUANGLE ADJUSTMENT AND LOCK (Figd)
9. krserl a screwdriver into the LOCKING GUIDE on the
LAMP/YOKE HOLDER, and locate the clot in the
VERTICAL ADJUST/LOCK SCREW, turn the SCREW
counterclockwise, and using the screwdriver as a
lever, tilt the entwe UMPIYOKE HOLDER to the
desired angle. Once the desired angle ie reached,
tighten screw by turning screwdriver clockwise.
HORIZONTAL ADJUST AND LOCK (Fig. J)
10. The entire IAMPIYOKE HOLDER can be horizontally
rotated to aim the an Ie of light as it leaves the hole
%
in the APERTURE TRI (Fig. J). This can be done by
backing off the HORIZONTAL ADJUST/LOCK SCREW
one full turn, freeing the SUPPORT PLATE (Fig J).
Grasping the YOKES on either side of the
LAMP/YOKE HOLDER, rotate the SUPPORT PUTE
to the desired angle and lock the position by
tightening the HORIZONTAL ADJUST/LOCK SCREW.
RELAMPING: The locking mechanisms designed within this
fixture allow ralamping without having to readjust and
relock. Follow Steps 5-8.
NOTE 1. LOW VOLTAGE FIXTURES should be
dimmed only with special dimmers Intended
apeclfloslly for that purpose Use Lightoiier
Lytemodej Soenlst, Cresoendo VA, Neptune VA,’
Preolelon VA, Essveet VA, Sunrise VA, Rediant VA or
IS1055LV
0890
Page 2
of 2
fs~
/.
-
==77=.
LAMP
SPRING
c
I-44:
GL4S&5L~MP
FIG. H
FIG. I
ET
equlvelant pfidu6te by others or vsrisbie auto.
transformer’e or eieotmnlo dimmers intended for use
with low voltage flxturee. 2. Low voltsge fixtures msy
produoe audible eound when used with externel
dimmem which may be ob]ectional in acoustically
critical eree%
DE
LAMP
GtiG~ARLMP
r LAMP
/
.
FIG. J
WARNING: USE ONLY REFLECTOR TRIMS PROVIDED By LIGHTOLIER INC. USE OF ~ER MANUFA~RERS’
RSFLECTDR TRIMS VOIDS THE UNDER~rERS LABORATORIES LISTING AND COULD CONSfTfUTE A FiRE HAZARD.