Filter
Top Products
INSTRUCTION SHEET NO,
1S:8629
R0992
Page 2 of 2
JACK ASSEMBLY BEFORE CLOSING
\
o
FIG. 3
MOUNTINGAND ADJUSTMENTS (FIG. 1)
1. lfusedwith POINTPOWER JACK#8605, usethecap marked "35WMN.'' (See fig.l.) lfusedwith other POWER JACKS,
make certain that the STEM BUSHING is removed from the POWER JACK.
2. Screw the JACK ASSEMBLY fully into the POWER JACK.
INSTRUCTIONSFOR LAMPING
CAUTION: MAKE CERTAIN THAT THE LYTEDROP FIXTURE IS COOL BEFORE HANDLING. SINCE THE LAMP
HEATS QUICKLY, MAKE SURE THAT THE POWER IS DISCONNECTED BEFORE INSERTING LAMP INTO
THE LAMP SOCKET.
1.
2.
3,
SEPARATE
Lift the GLOBE ASSEMBLY (with STYLE JACK SHADE) while rotating to the LE~ until it is released from the SOCKET
HOLDER (Fig. 4).
INSTALL LAMP
CAUTION: DO NOT TOUCH THE LAMP WITH BARE HANDS.
OIls from the hands could reduce LAMP life. Use tissue paper or soft cloth. Inserl the LAMP into the SOCKET holes as far
as it will go. Pins will be exposed approximately 1/16“ outside of the SOCKET when fully engaged. No polarity of pins is
required.
REASSEMBLE (Fig. 5).
FIG. 4
%
SOCKET HOLDER
L4MP (SEE NOTE)
.0 GLOBE
MBLY
TYPICAL STYLE
SHADE
LOBE
TO SEPARATE
FIG. 5
nt
i-
“=’
TO REPLACE
I
..