Lightolier 83ED17 Indoor Furnishings User Manual


  Open as PDF
of 2
 
COMPATIBLE LUMINAIRES
Cat. No. Product Group Description
8387 ED17 50W Magnetic HID Lytespot
8387E ED17 50W Electronic HID Lytespot
8388 Lytespan Track ED17 70W Magnetic HID Lytespot
8388E ED17 70W Electronic HID Lytespot
8389E ED17 100W Electronic HID Lytespot
PDE17 Series ED17 HID Pull-Down
SRE17 Series
Calculite
ED17 HID Semi-Recessed
Fig. 1
REFLECTOR
REFLECTOR
SPRINGS
REFLECTOR
CUP
ACCESS
KNOB
ED17 LYTESPOT
ACCESSORY
CARTRIDGE
LIP
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE.
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:83ED17
C0104 Page 2 of 2
INSTRUCTIONS FOR ATTACHING 83ED17R SERIES REFLECTORS TO
ED17 HID LYTESPOTS SERIES LUMINAIRES.
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
INSTRUCTIONS FOR ATTACHING 83ED17R SERIES REFLECTORS TO AN HID
ED17 LYTESPOT LUMINAIRE:
(See chart below for compatible luminaires)
NOTE: Reflectors must be installed prior to lamps. After reflector is assem-
bled, see IS:8387 for Lytespot installation, lamping, accessory, and operating
instructions.
1. If Lytespot is already attached onto a track, make sure power to the
track is turned off before proceeding.(Lytespan Track luminaire is
shown in Figs. 1 & 2. Instructions 2-4 are the same when using
Calculite luminaire.
2. Holding ACCESSORY CARTRIDGE, loosen ACCESS KNOB a few turns
until ACCESSORY CARTRIDGE opens. SWING the CARTRIDGE open
for access to REFLECTOR CUP (See Fig. 1).
3. Holding REFLECTOR by the LIP, push REFLECTOR into REFLECTOR CUP
until REFLECTOR SPRINGS engage (See Fig. 2)
4. Rotate REFLECTOR clockwise until the REFLECTOR SPRINGS
hit the ROTATION STOPS on the REFLECTOR CUP (See fig. 2).
To remove REFLECTOR, remove lamp, rotate REFLECTOR
counter-clockwise until REFLECTOR SPRINGS snap off into
REMOVAL SLOTS. Pull REFLECTOR out of REFLECTOR CUP
(See fig. 2).
Fig. 2
REFLECTOR
REFLECTOR
SPRINGS
ROTATION
STOP
REMOVAL
SLOT
 previous