Filter
Top Products
/
\
READ AND UNDERSTAND THESE iNSKiUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTION SHEET NO.
~~1~ fi~re i5 jntended for installation in
amrdancz with tie National Eiectrirzl Code and 10d
~eoula~ons.To assure full campliancevfi!! local
males and regulations, Cheti with you; Iod elecrrd
“[s:a9 ,10
inspector
beroreinstallation. To prevent elecbical shock,turnoff,electriaty atfuseboxbeiore proceeding.
Retain these instructions for maintenance reference.
“--1094 PAGE”2 “OF 21:
——.,,———...—... .- .—-—.
I
I
I
.-
. . .. . .
.
,. -.. .
NOTE :
For supply connections use wire rated for “at least 75° C.
__.._:-——-J
WARNING-RISK OF FIRE.. Most dwellings built before 1985 have supply
wire rated 60° C.
~consult”.a,.qualified electrician before
installation.
;’.7.
CAUTIO.~: Push SUPPIY wires.and wir”enut c~nriections back into j-box
:?
2. Mount FIXTURE BODY to MOUNTING PLATE by aligning HOUSING TABS
up ,,through RECTANGULAR SLOTS in MOUNTIN~ PLATE.
CAUTION: Make certain that no wires are pinched between mounting
plat,e and fixture body.
.3.
Gen$ly push fixture body against wall until MOUNTING STUD comes
thcough SLOT in FIXTURE BODY.
Secure in place using battery nut
4.
Install recommended lamp.
CAUTION: Maximum wattage marked on fixture must not be exceeded.
5.
Install GLASS
over two THEADED STUDS WITH etched pattern on
glass facing down,
tighten two THREADED BALLS onto THREADED
STUDS to secure glass. Do not overtighten!’
Note: glass should be
sure on front portion
-.
1
!
I
1
---
I
removed for cleaning as undue downward pres-
could cause glass support bracket to bend.
,..,
.. -
.
;
..:,
,,
. . . .
-...’
.-
.—.—. .—-. .
. . . . .-_— ... - .-
—
r
,..
(
-L-.