Filter
Top Products
IV. A~ACH MOUNTING RING
Insert MOUNTING RING into CEILING as shown
(Fig. H).
CLIP ASSEMBLY (Fig. 1)
1. Insert CLIP from inside housing, through ‘T’ slot.
2. Apply downward force with screwdriver on top of
CLIP or engage screwdriver in slot in CLIPS flange.
3. Apply force until CLIP is snugly seated.
LoT
PRING
CLIP REMOVAL (Fig. J)
1.
Insert a small blade, short-handled screwdriver
through the CLIPS’S screwdriver slot, and press
against the opposite side of the CLIP
2. Push CLIP up to top of ‘T’ SD and remove.
V. SNAPON (Fig. E)
I
SEE SEPARATE
REFLECTOR TRIM
INSTRUCTION
VI. PUSH-UP (Fig. F)
SHEETS
C“L”G\’&,
7
‘w,
[.
FIG. H
TO INSERT
‘f
INSIDE OF
\
HOUSING
Y
\
‘., r
STEP 1
T1
... ,
,(
‘T SLOT
SHORT HANDLE
IN HOUSING
J
SCREWDRIVER
STEP 2
_.
*’
STEP 3
LJ
LcI=lL1’G
FIG. I
FIG. J
t
4
WARNING: USE 0NL% REFLECiOR TRIMS PROVIDED BY LIGHTOLIER INC. USE OF UTHER
MANUFACTURERS’ REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND
COULD CONSTITUTE A flRE HAZARD.