Filter
Top Products
– 5 –
E
Changing the dust bag
The dustbag needs changing when the cleaner
is set to maximum power and the cleaner head
is off the floor but the “bag full” indicator
window(17) is completely coloured red.
Even if the dustbag does not appear to be
full at this stage, it should be changed.
It could be that a great deal of very fine dust
has clogged up the pores of the dust bag.
• Turn off the appliance and unplug it.
• Open the cover by pressing the hook(18)
and lifting it up until it snaps into place.
Your appliance is equipped with either a
paper dust bag (19) or a fabric dust bag
(21)(depending on model).
• Take hold of the dust bag by the handle
and pull.Remove the bag and throw it
away.
• To refit a new bag push the cardboard
support of a new bag into the bag mount
(20)until it will go no furthe
r.
If your appliance is fitted with a fab-
ric dust bag follow the same instructions
as above.
Empty it and replace it(21).
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
fitted correctly.
Cleaning the motor filter
The motor filter is situated inside the
appliance between the dust bag and the
motor. Each time that you change the air
outlet filter we advise you to remove the
motor filter(22)and to clean it by tapping to
remover the dirt and then replacing it in the
vacuum cleaner.
Check that the appliance is correctly plugged
in and that the electrical socket is working.
• Stop the appliance and unplug it.
• Check that the tubes, flexible hose and
cleaning tool are not blocked.
• Check that the dust bag is not full.Replace
if necessary.
What to do if your appliance
does not work?
What to do when the suction
performance reduces?