Filter
Top Products
Owner’s Manual 13
ENGLISH
Installation
Cabinet Installation
1. Open the window. Mark a line on center of
the window stool(or desired air conditioner
location).
Carefully place the cabinet on the window
stool and align the center mark on the
bottom front with the center line marked in
the window stool.
2. Pull the bottom window sash down behind
the upper guide until it meets.
Do not pull the window sash down so
tightly that the movement of Frame Curtain
is restricted.
3. Loosely assemble the sill support using
the parts in Fig. 3.
4. Select the position that will place the sill
support near the outer most point on sill
(See Fig. 4)
Be careful when you install the cabinet
(frame guides are broken so easily).
5. Attach the sill support to the cabinet track
hole in relation to the selected position
using 2 Type A screws in each
support(See Fig. 4).
6. The cabinet should be installed with a
very slight tilt(about 1/2") downward
toward the outside (See Fig. 5).
Adjust the bolt and the nut of sill support
for balancing the cabinet.
7. Attach the cabinet to the window stool by
driving the screws
(Type B: Length
sixteen millimeters and below.) through
the front angle into window stool.
8. Pull each Frame curtain fully to each
window sash track, and repeat step 2.
NOTICE
NOTICE
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Upper Guide
Window Sash
Window stool
Front Angle
Upper guide
Frame Curtain
1
Foam-pe
Foam-pe
12
Cabinet
INDOOR OUTDOOR
INDOOR OUTDOOR
Sash track
Front Angle
Cabinet
About
1
/2"
About
1
/2"
Sill Support
2
Nut
4
Bolt
3
Frame Guide
10
Screw(Type B)
6
Screw(Type B)
6
Sill support
2
Sill support
2
Screw(Type A)
5
10
Screw(Type B)
3
Frame Guide
10