Filter
Top Products
Med
Fan
Off
Low
Fan
High
Cool
Med
Cool
Low Cool
Operation
6
7
8
9
5
1
2
3
4
Thermostat
C
o
o
l
e
r
Operating Instructions
Owner’s Manual 11
ENGLISH
Controls – Cooling Only
Operating Instructions
The controls will look like one of the following:
• FOR NORMAL COOLING
1. Turn the Operation Knob to the High Cool from the
Low Cool setting.
2. Set the Thermostat control to the desired
temperature mark 5 (the mid-point is a good
starting position). If the room temperature is not
satisfactory after a reasonable time, adjust the
control to a cooler or warmer setting, as
appropriate.
• FOR MAXIMUM COOLING
1. Turn the Operation Knob to the High Cool setting.
2. Set the Thermostat control to the largest
9
temperature mark.
• FOR QUIETER OPERATION
1. Turn the Operation Knob to the Low Cool setting.
2. Set the Thermostat control as needed.
• ENERGY SAVER (optional)
On : Both the fan and the compressor turn on and
turn off together while operation knob is set to
the Cool position.
You can get the more economical operation.
Off : The fan runs constantly while operation knob is
set to the Cool position.
You can access the Energy Saver switch when you
open the inlet grille.
Off - Turns air conditioner off.
Med Fan - Med speed fan operation without cooling.
Low Fan - Low speed fan operation without cooling.
High Cool - Cooling with high speed fan operation.
Med Cool - Cooling with med speed fan operation.
Low Cool - Cooling with low speed fan operation.
This automatically controls the temperature of the indoor air.
Turn the knob so that arrow points to the larger marks for
greater cooling. Point the arrow to the smaller marks for more
moderate cooling.
(i.e. the higher number, the greater cooling)
Off On
Energy Saver
PTAC DIRECT SALES (877) 454-7822