Filter
Top Products
Timer
Air
Purifier
AIR
PURIFIER
Power
Temp
Timer Mode
Auto
Swing
Fan Speed
1
5
2
4
3
52 4
31 6
6
Remote Control Operations
Operating
Instructions
The remote control and control panel will look like those represented in the following pictures.
Remote Control Operations
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its last setting.
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode,
high fan speed, temperature setting at 72˚F.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
60°Fto86°F by increments of 1°F.
MODE
- Every time you push this button, it will cycle
through the following modes: COOL, ENERGY
SAVER, FAN and DRY.
- ENERGY SAVER
• The fan stops when the compressor stops
cooling. Approximately every 3 minutes the fan
will turn on and the unit will check the room air to
determine if cooling is needed.
FAN SPEED
• Every time you push this button, it advances the
setting as follows: {High(F3) → Low(F1) →
Med(F2) → High(F3)}
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you
sleep.
• With unit running, use Timer to set number of
hours until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 min,
and 2°F after another 30 min.
• Every time you push Timer button, it advances
the Timer setting as follows: 1 Hour → 2 Hours →
etc. → 12 Hours maximum.
- START TIME
• With unit not running, use timer to set number of
hours before unit starts.
• Every time you push Timer button, it advances
the Timer setting as follows: 1 Hour → 2 Hours →
etc. → 12 Hours maximum.
REMOTE CONTROL SENSOR
6
5
4
3
2
1